Disco Rubber Butstock

[CitySniper]

where do i buy one?

[Big_Bill]

They may not have the best prices, but they do have the best quality !

www.brownells.com

Bill

[CitySniper]

thanks Bill....is this the one?

http://www.brownells.com/.aspx/pid=6379/Product/RECOIL_PAD__RUBBER__DOUBLE_VENT__GUNSMITHING_REQUIRED


what is needed to install? lol I was hoping to just screw it on

[Truman]

Darius, I've just done the same thing! I asked this question a few weeks ago and got some excellent advice from the guys! Here's the link.

http://www.gatewaytoairguns.com/airguns/forums/thread-view.asp?tid=26259&posts=15#M208250

And here's the finished results.

http://www.gatewaytoairguns.com/airguns/forums/thread-view.asp?tid=26932&posts=4#M212636

Hope that helps a bit!
Try to get the closest fitting one you can! I used an angle grinder to do the shaping but I think a belt sander would give better results!
Andy

[Big_Bill]

It would be up to you Darius,

But that is a straightshotgun recoil pad, you might be interested in a curved rifle recoil pad !

$48.00 is a little steep !

I believe that Natches also sells recoil pads like Pachmayr for around $25+

I know that the Air Gun Companies don't spend that much for them, heck, you can buy a whole stock, with the pad for less than that.

Bill

[CitySniper]

thanks Bill, ....Andy that looks pretty good, I bet that gun shoulders nice.

[Truman]

Yes, it feels a lot more comfy to shoulder! Before it always felt like it wanted to flop forward, but now it just sits where I put it! Also with the added weight up front, it helps slow the shakes down to a controllable level! LOL!! It was well worth the effort because it has changed the whole feel of the disco!